Storefront Doors in Peachtree Corners, installed and replaced.
Storefront door installation and replacement for shops, restaurants and clinics in Peachtree Corners — aluminum and glass entrances on Peachtree Parkway, Holcomb Bridge Road and Spalding Drive, matched to the center's frontage. Free written estimate.
Tempered glass, measured to the stilePivots and closers replaced, not just tightenedFree written estimate, same-day when we can
FreeWritten estimates
21Services, one crew
13Metro Atlanta towns served
Same-dayService when the schedule allows
Peachtree Corners businesses
Peachtree Corners storefronts see more foot traffic than their doors were built for.
The retail in Peachtree Corners is concentrated along Peachtree Parkway: The Forum's open-air shops on one side, the newer Town Center restaurants on the other, and the strip centers that run north and south of them. Most of those entrances are narrow-stile aluminum doors with tempered glass, and the ones in older centers have opened and closed several hundred times a day for years. By the time an owner calls, the pivots are worn, the closer has lost its control and a corner joint has started to work loose. At that point a new door in the existing frame usually costs less over the next few years than another round of repairs.
Replacement in a Peachtree Corners shopping center has a second party in it: the landlord. Many centers set the finish, the stile width and the hardware for every tenant entrance so the frontage matches, and some want the work done before the shop opens in the morning. We ask for the center's tenant rules before we quote, match the finish and sightlines of the doors beside yours, and plan the swap so the entrance is closed for as short a time as the job allows.
Away from the Parkway, along Holcomb Bridge Road, Spalding Drive and Jones Bridge Road, the storefronts belong to smaller centers with restaurants, salons, dentists and dry cleaners, where a new tenant often inherits a tired door along with the lease.
Technology Park, along Technology Parkway between Peachtree Parkway and Peachtree Industrial Boulevard, adds a different kind of entrance: the aluminum and glass lobby doors of offices and flex buildings, often a pair with a center mullion. Many of those already have a card reader beside them and an electric strike in the frame or mullion, so a replacement door has to be prepared for the same hardware, and the estimate says how the reader is reconnected when the new door is hung.
What we do
Everything on a storefront entrance.
A storefront door drags, then chips the floor, then stops latching, then the glass cracks at the corner. Each step is cheaper to fix than the next one.
New storefront doors
Narrow, medium and wide stile aluminum doors, single or in pairs, with the frame and sidelites, glazed with tempered glass and fitted with the closer, lock and pull you choose.
Commercial glass doors in offices and lobbies
Aluminum-framed and all-glass doors at office suites, medical offices and condo or apartment lobbies, repaired and replaced like a storefront.
Glass replacement
Cracked or broken door glass secured and replaced with tempered glass cut to size. Insulated units where the entrance is heated and cooled.
Pivots and hinges
A door that drags or sits crooked usually has a worn bottom pivot or a loose top pivot. Replaced, and the door re-hung level.
Closers
Surface, concealed overhead and floor closers replaced or rebuilt so the door closes fully and quietly instead of slamming or hanging open.
Locks and hardware
Hookbolt and deadlatch locks, cylinders, thumbturns, push-pull bars and panic hardware fitted to aluminum stiles the right way.
Weatherstrip and sweeps
The brush and pile weatherstrip that stops the draft, the dust and the water at the threshold — the part that is missing on most doors we see.
The same door coming back every six months is a door that was adjusted instead of repaired. On every storefront door we work on:
Free written estimate after we look at the door
The failed part named, not just the door tightened
Tempered safety glass, measured to the stile
Pivots replaced and the door re-hung level
Closer sized to the door and adjusted to latch
Locks and cylinders fitted to aluminum stiles properly
Opening secured while glass is on order
Same-day service when the schedule allows
The quote
What storefront door work costs.
A pivot is a small number and a new pair of doors with sidelites is a large one. What decides the estimate is which part failed and whether the frame is still worth keeping.
Always included
Site visit and a free written estimate
Failed pivots, closers, locks or glass identified in writing
Tempered glass cut to size and glazed
Pivots, hinges and closers replaced and adjusted
Locks, cylinders and pulls fitted and keyed
New doors hung, glazed and adjusted to latch
Weatherstrip, sweep and threshold
Old door, glass and packaging hauled away
What changes the number
Repair against replacement: whether the door and frame are worth keeping
Single door or a pair, and the stile width
Clear, tinted or insulated glass
Surface closer, concealed overhead or floor closer
Standard lock or panic hardware on an exit door
Whether the frame or sidelites are replaced with the door
Good to know
Storefront doors questions from Peachtree Corners.
Your question is not here? Call (470) 691-8439 and put it to the crew directly.
Our center requires a specific door finish. Can you match it?
Yes. Aluminum storefront doors come in standard anodized and painted finishes and in narrow, medium and wide stiles, and we match what the center specifies and the doors beside yours.
Does the shopping center have to approve our new door?
Usually, yes: a shopping center lease often gives the landlord a say over anything on the frontage. We put the finish, stile width and hardware in the written estimate so you can send it to the property manager before anything is ordered.
How long will our entrance be out of use?
A door swapped into an existing frame is usually a single visit, and we can plan it before opening when the schedule allows. If the door has to be made to order, the old one stays in service, or the opening is secured, until the new one arrives.
Our storefront glass was broken overnight. What happens first?
When the schedule allows, the opening is made safe the same day, so the shop can lock. Then we measure for the permanent repair: new tempered glass in the old door if the door and frame are sound, or a new door if they are not. The written estimate shows the board-up and the permanent repair, so the total is clear from the start.
Send the form and we call you back the same business day with a time for a walkthrough or a same-day visit. Every number you get from us is in writing.
